Build Year: 1989

Used For: Crabber

Hull: Steel

Length: 17.30m

Beam: 6.20m

Draft: 2.50m

Licence:

NO LICENCE, LICENCE REQUIRED WOULD BE 119 GT AND 233 KW (THAT IS THE DE-RATED FIGURE )

Engine:

CUMMINS NT1855-M - MAIN
PERKINS GEN SET
DOOSAN GEN SET

Hydraulics:

HYDRAULICS CAN BE RUN FROM EITHER THE MAIN ENGINE OR THE DOOSAN GEN SET

Electronics:

USUAL ALL OWNED

Additional Information:

BOAT WAS PURCHASED IN LATTER PART OF 2014 AND WAS CONVERTED FROM A GILL NETTER TO A VIVIER CRABBER
CUMMINS MAIN ENGINE COMPLETELY OVERHAULED IN MAY 2018 WITH A NEW CAMSHAFT FITTED IN 2019, NEW TWIN DISC GEARBOX FITTED MAY 2018. IINJECTORS REPLACED EVERY YEAR BY CUMMINS ALTHOUGH THEY RECOMMEND 18 MONTHS
PURCHASED ORIGINALLY WITH A PERKINS GEN SET WHICH WAS REPLACED 2019 WITH ANOTHER PERKINS OF THE SAME. DOOSAN WHICH WAS PUT IN NEW AT TIME OF CONVERSION WAS COMPLETELY OVERHAULED IN 2019
2 TON BRITANNIA HAULER
15 TON VIVIER TANK WORKED WITH 2 AZCUE PUMPS
2 BAIT STORES
1 CHEST FREEZER DOWN BELOW
NEW OVEN, NEW FRIDGE FREEZER AND NEW WASHER/DRYER
RADIO SURVEY AND MEGGAR TEST CONDUCTED MAY 2020

BOAT HAS HAD A FULL PAINT, NEW ANODES. SEACOCKS AND DISCHARGES BEING REMOVED IN FRASERBURGH FOR SERVICING AS WELL AS THE SHAFT BEING LIFTED FOR CLEARANCE MEASURING.
FIRE EXTINGUISHERS SERVICED 1.5.2020 AND NEW STAT EX FIRE SYSTEM BEING INSTALLED IN ENGINE ROOM WHILE IN FRASERBURGH
COMPASS SWUNG 1.5.2020
STEEL TEST AVAILABLE FOR HULL DATED 5.2019, SPOT CHECKS WILL BE DONE AGAIN IN PRESENCE OF INSPECTOR IN FRASERBURGH


The vessel IS going onto Fraserburgh slip on Wednesday 29th July for its out of water inspection then it will get it’s in water incline test on the 5.8.20 to complete the 5yr DTI certificate


OFFERS CAN BE SUBMITTED IN CONFIDENCE TO:

GILL SUMMERS
BRODIES LLP
23 CARDEN PLACE
ABERDEEN
AB10 1UQ

[email protected]

PLEASE ONLY SEND FULL OFFERS TO THIS EMAIL. Any general enquiries please contact number to the phone number in the advert